EPEVER MPPT Solar Charge Controller 40A W/ MT50 Remote Meter

  • $214.99
    Unit price per 

  • Negative Grounding MPPT Solar Charge Controller Tracer4215BN, The Advanced MPPT Control Algorithm makes this 40 Amp MPPT Controller Tracking Efficiency higher than 99.5%
  • 150V Max PV Input Allow this Charge Controller Handles More Solar Panels Wiring in Series to minimize PV current, 5 x 12V Solar Panel Connecting in Series will be applicable
  • Work with all Lead Acid Batteries, Sealed AGM GEL and Flooded Battery, User mode allows buyer setting their own charging parameters.
  • RS-485 communication bus interface and Standard MODBUS interface available to meet various communication requirements, Temperature Sensor and PC monitoring Cable Attached
  • This 40 amp MPPT Solar Panel Charger works with 600W Solar Panel on 12V Battery System and 1200W on 24V Battery. Max Solar Panel 1560W, multiple load mode allow you set the load on/off in different situation. A Solid State Relay is recommended if you are using a Power Inverter
40A MPPT Solar Charge Controller with Remote Meter And Temperature sensor / PC monitoring cable.
The Package included the following item:
1. 40A MPPT Solar Charge Controller
2. MT-50 Remote Meter
3. Battery Temperature Sensor
4. PC Software Communication Cable

40A MPPT Charge Controller Technical Data
Nominal System Voltage: 12V, 24V
Max Battery Current: 40A
Nominal Maximum Operating Power:
12 Volt 520W / 24 Volt 1040W
Peak Efficiency: 99%
MPP Voltage Range: Battery Voltage +2V~108V
Maximum PV Open Circuit Voltage(VOC): 150V
Dimension: 303x183x64mm / 11.93x7.2x2.52 inch
A higher than rated input power will not damage the controller as long as its under 3 times the rated value, but do not exceed Voc.
Exceeding Max PV Open Circuit Voltage May Damage the Controller

MT50 Remote Meter
Faceplate dimension:98×98 mm / 3.86×3.86 inch
Frame dimension:114×114 mm / 4.49×4.49 inch
Connector type: RJ45
Meter cable:Standard 2m,Max 50m
Ambient Temperature: -20°C -- +70°C/-4°F -- 158°F

Remote Temperature Sensor
Acquisition of battery temperature for undertaking
temperature compensation of control parameters
Length: 3 M

USB to RS485 Converter Adapter
This adapter is used to monitor each controller on the network using Solar Station PC software and update the firmware.
You will find the software download link printed on the inside of the packing or contact us to get the download link.